Manufacturing of Kapur Wood (Dryobalanops spp.) Particle Board and Its UV-Radiation Curing of Surface Coatings

Sugiarto Danu, Darsono ., Adjat Sudradjat

DOI: http://dx.doi.org/10.17146/jair.2011.7.1.495

Sari


Research on manufacturing the kapur (Dryobalanops
spp.) particle board has been conducted using the mixture of clover leaf oil by products and
tannin after being mixed with phenol and formaldehyde as adhesives. Particle board was prepared by molding process while pressing and heating. Particle board measured by using
SNI 01-2105-1991 have physical properties i.e. density, water content, thickness swelling meet the standard whereas the mechanical properties i.e. modulus of elasticity, modulus of rupture, internal bond strength, and screw holding strength do not meet the standard. Ultra-violet cured polyester coatings on particle board have pencil hardness of 2B — 2H, medium gloss (36— 58 %), adhesion meet ASTM D 2571-71, and most failure patterns occur on particle board part. In general, polyester coats do not resist against 10 % sodium hydroxide solution

Teks Lengkap:

PDF

Refbacks

  • Saat ini tidak ada refbacks.


Bookmark and Share


___________________________________________________________________________________________

Terindeks oleh:

      

___________________________________________________________________________________________

Copyright:

Jurnal Ilmiah Aplikasi Isotop dan Radiasi (A Scientific Journal for the Applications of Isotopes and Radiation)

e-ISSN 2527-6433 

p-ISSN 1907-0322

___________________________________________________________________________________________

Homepage : http://jurnal.batan.go.id/index.php/jair
___________________________________________________________________________________________